Shutoff adjustment First, adjust the gap when the contacts are separated to 0.7 to 0.9 mm. Remove the wires from the battery and armature terminal on the regulator, and then use the battery fire wire to touch the armature terminal and use the battery power to aspirate the active arm of the choke. In the event of a fire, relax the shut-off spring so that the magnetized core sucks the moving arm and then tightens the spring while hitting the fire until it is just not able to suck the arm. This means that the choke spring is suitable for a voltage of 12V. Then adjust the spring appropriately to experience a slight increase in the closing voltage. After the closing voltage is adjusted, connect the removed battery and armature wiring and start the engine for testing. At idle, the ammeter pointer shifts slightly toward the discharge direction, and then the speed is increased to make the current pointer point to the charging direction. When the speed is slowly reduced to a certain value, the ammeter pointer points to discharge and snaps back to zero. The maximum value of the current meter pointer when it swings backward is the reverse current value, and its value should meet the requirements. Current regulator adjustment The battery is in a half-discharge state (if the power is sufficient, the electric starter can be used to start the generator 2 or 3 times), and a wooden block is inserted between the active arm of the pressure regulator and the iron core to close the pressure regulator contacts. Loss of pressure regulation. Then increase the engine speed to medium speed, then the current meter pointer current value should be 3/4 of the specified value. To continue to increase the speed, and the current value indicated by the ammeter no longer increases, and there is a weak spark between the current limiter contacts, it should be considered normal. Regulator adjustment A wood chip is inserted between the movable arm of the current limiter and the iron core to close the contacts of the current limiter. The generator is operated at a medium speed, and the elastic force of the spring is changed to adjust the terminal voltage of the generator. If the battery is depleted, the ammeter indicates approximately 12A (the depleted charge value). If the battery is fully charged, the ammeter indicates approximately 8A, and the terminal voltage of the generator approaches the standard value. Dehydrated Asparagus,Dehydrated New Crop Green Asparagus,Ad Good Quality White Asparagus Powder,Air-Dried White Asparagus Powder Xinghua Jiahe Foods Co., Ltd. , https://www.jiahefoods.com
Learn "Three Adjustments" with Tractors