Half Cut Crab,Frozen Cut Crab Seafood,Half Cut Blue Swimming Crab,Frozen Portunus Trituberculatus Zhoushan Haiwang Seafood Co., Ltd. , https://www.haiwangseafoods.com
Red jujube cleaning machine cleaning jujube process>
The consumption of jujube has a high nutritional value, and most people like it and often use it as a stew. But do you know that during the drying process, red dates are stained with a lot of “garbage†in the wrinkles of the jujube skin. How can you wash it with water? If it is a small amount, we can use manual cleaning several times, but what if it is a lot? At this time, the red jujube washing machine is used to promote the power. Of course, the jujube washing machine can also be used for household use. How does it clean the red dates?
Red jujube washing machine fresh jujube process: raw material - picking - cleaning - drying - picking - lifting - oiling - grading, working by the speed control motor through the transmission part to drive the mesh belt forward, while bubbling and rear jet Under the joint action of the propeller, the material is tumbling and vibrating in the water to achieve the purpose of cleaning.
Operation of jujube washing machine :
1. Preparation before cleaning
1) Check whether the equipment has loose fasteners, whether the belt is intact or not, the net has no disconnection, residual wire, deviation, whether the water pump and the foaming machine rotate normally, whether the spray is smooth, whether the electrical switch is switched normal.
2) Fill the circulating water tank and the two bubble washers with clean water. And install the filter on the circulating water tank.
2, boot essentials
1) When starting the whole processing line, first turn on the beverage pump, which is the 9, 5, and 4 buttons in turn. The middle pauses for a while and then turns on. After all the beverage pumps are turned on, the bubble cleaner is turned on in turn. Remove the cleaning machine and then turn on the vibrating fabric hoist to adjust the appropriate cutting speed.
2) In the following productions, the following inspections should be carried out: whether the vibrating fabric hoisting machine is uniform, whether the spraying pressure is insufficient, and whether the fresh water supply is sufficient.
3, the shutdown is also very particular
Before the whole production line is shut down, shut down the vibrating fabric hoist, a bubble washing machine, a hair cleaning machine, a two-stage bubble washing machine, and finally close the water inlet valve.
After all equipment has been shut down, first open the drain valve to drain the water from the equipment. Next, clean up the residual materials in the bubble cleaner and the hair to the residual brush. Then use a high-pressure cleaner to clean the cylinder chamber of the bubble cleaner, and the hair is removed from the cleaning machine cylinder and the filter screen of the circulating water tank. Finally turn off the power to the device and press the emergency stop button.
Next Article
Walnut winter management