How to use the vegetable cutter safely

With the development of society, the vegetable cutting machine gradually entered our life, but for this large kitchen equipment, we still don't know clearly, then how to run the cutting machine, about the accident caused by improper use of the cutting machine Abound, below, Xiaobian will introduce you to the safe use instructions of the cutting machine, I hope to help everyone in Taizhou company registration.

1. Try cutting before work, and observe whether the specifications of the cut vegetables are the same as the required specifications. Otherwise, the slice thickness or the length of the cut vegetables should be adjusted, and the normal work should be carried out after meeting the requirements.

2. Install the vertical knife 1 intelligent vegetable cutting machine to install the vertical knife: put the vertical knife on the fixed knife plate, the cutting edge is in parallel contact with the lower end of the fixed knife plate, the fixed knife plate pin is on the knife holder, the cutter nut is fastened, and the cutter is removed. The knife can be fixed. 2 Other cutting machine installation vertical knife: first turn the adjustable eccentric wheel, so that the tool holder will go to the bottom dead center, then the Taizhou company registers to raise the knife holder up 1/2 mm, so that the vertical knife contacts the conveyor belt. Fasten the nut and fasten the vertical knife to the tool holder. Note: The elevated height of the elevated can be mastered according to the vegetables being cut. If the elevated height of the overhead is small, the vegetables may have a knife. If the elevated height of the overhead is too large, the conveyor belt may be cut.

3. Length adjustment of cut vegetables: Observe the length displayed on the control panel. The registered value of Taizhou company matches the required length. Press the increase button when increasing the length and the decrease button when the length is reduced. Other cutting machine adjustment: turn the adjustable eccentric wheel, loosen the connecting rod fastening screw, cut the filament to move the fulcrum, from the outside to the inside; when cutting the thick wire, you can move the fulcrum, from inside to outside, adjust and tighten Screw.