After receiving the linear vibration screening equipment, you need to read the instruction manual of the random packaging after removing the transportation support card. There is a general outline of the working principle of the linear sieve. Then follow the steps below to check carefully: 1. Before running the linear screen, be sure to fix the channel steel of the chassis, which can be fixed on the ground foundation. The base also needs to be fixed firmly, so that the height difference between the front and rear support seats can be the same, the same end (feeding end) Or the support plates on both sides of the discharge end are in the same horizontal plane, the error is within 2mm, that is, the linear sieve is in a horizontal state. 2. The connection of each part of the linear sieve machine must be firm and reliable. All bolts must not be loose. The parts must not have any abnormal sound. The minimum clearance between the vibration part of the sieve machine and the surrounding fixture is 30-50mm. Is the bundle ring screw of the body frame locked? 3. The linear screen frame is made of wood with less deformation to keep the screen flat and tight and to achieve normal screening. If the metal screen frame is used in the machine if the specific gravity is large or the output is large, it is necessary to pay attention to check whether the screen is flattened. 4. In the process of transportation, in order to increase the rigidity of the linear screen, the transportation support should be added. Before the first start-up operation, the transportation support must be removed. Otherwise, the vibration of the vibrating screen will be affected, and the machine will be damaged seriously. 5, linear screens are generally three-phase electricity, so it must be ensured that the power supply should be properly connected, no phase loss operation. 6. Finally, after the first boot, pay attention to the material track, and adjust the running track to the state you need according to the screening material. 1. The screen should not be damaged or blocked, and it should be pressed on the structural frame. 2. Check if the amount of vibrator oil reaches the specified oil level and whether the vent hole is ventilated. 3. Check the original bolts to ensure their tightness, especially the bolts that fix the vibrators. The damping spring must be intact. 4. Check if the tension of the V-belt is moderate and avoid slipping during starting or working. 5. Turn the vibrator by hand or other methods, the rotation should be flexible, no jamming phenomenon. 6. Check if there is any accumulated material on the screen surface to prevent starting difficulties. Note on the operation of linear vibrating screen: 1. When running production, the feeding must be uniform and distributed over the entire screen surface. If there is too much ore to crush the vibrating screen, it should be immediately notified to stop the ore and be quickly and effectively disposed of. 2. Pay attention to whether there is strong noise in the sieve, and the sieve vibration is not allowed to have an abnormal swing phenomenon. When the sieve is shaken, It should be checked whether the elasticity of the four support springs is consistent or not. 3. Always observe whether the screen is loose or not, and whether there is any leakage of mine due to local wear of the screen. If these conditions occur, the maintenance personnel should be notified to deal with it. 4. In normal operation, the bearing temperature should generally not exceed 75 °C. If the temperature continues to rise, check the oil level, oil level and oil cleanliness. 5, pay attention to keep the vibrator vent hole unobstructed, if the blockage easily lead to bearing heat.  The need to pay attention to the normal shutdown of the linear vibrating screen: 1. When the machine is shut down, all the materials on the screen surface must be unloaded, then stop driving the motor and close the water valve. 2. After the machine is shut down, the equipment should be inspected and the maintenance and care work of the vibrating screen should be done. Collapsible Foot Spa,Foot Spa Bath Massager,Foot Bath Spa Massager,Foot Soak Tub Huaian Mimir Electric Appliance Co., LTD , https://www.mimirfootspabath.com
The linear vibrating screen needs to be checked before starting up: 
What to pay attention to when using the linear vibrating screen for the first time
Prev Article
Jujube drought prevention